TOP 2 - FLOOR (10m) - 0.50 HP clear water drainage pump
Flow rate up to 150 l/min (9.6 m³/h). Head up to 8.5 m. 0.37 kW (0.50 HP) motor. 10-meter cable with Schuko plug.
The TOP 2 - FLOOR submersible electric pump from the TOP-FLOOR series by Pedrollo is among the best in the submersible drainage category.
Thanks to its ability to suck water up to 2 millimetres from the bottom, it is suitable for emergency domestic use in small flooded rooms and in all those applications where maximum levels of drainage are required.
It allows the passage of suspended solids up to 2 millimetres in diameter.
It can be installed up to 3 meters below the water level.
To create the TOP 2 - FLOOR, Pedrollo used a mix of technopolymer, noryl and stainless steel which give solidity and robustness.
- Motor connection
- SINGLE-PHASE
- Power (HP)
- 0.50
- Absorption at 230V (A)
- 2
- Capacitor
- 10 µF 450 VL
- Delivery mouth
- 1" 1/4
- Pump body
- Technopolymer
- Impeller
- Noryl
- Number of impellers
- 1
- Crankshaft
- Stainless steel EN 10088-3 1.4104
- Check valve
- Yes
- Degree of protection
- IP 68
- Minimum flow rate (l./min.)
- 20
- Max. flow rate (l./min.)
- 150
- Min. head (m.)
- 2.4
- Max. head (m.)
- 8.5
- Cable length (m.)
- 10
- Jobs
- drainage
drying up - Max. liquid temperature (°C)
- +40°C
- Height (cm)
- 25.7
- Width (cm)
- 15.2
- Weight (Kg)
- 5
- Warranty (years)
- 2
TOP models and performances - FLOOR
|
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Construction data of the TOP series

Bearings
| Pump side motor bearing | 6201 ZZ |
| Opposite side engine bearing | 6201 ZZ |
Tree holding
| Type of seal | Double Seal: Mechanical and Lip with oil chamber |
| Engine side model | Lip seal |
| LM diameter | 12 |
| LM elastomer | NBR |
| Shrinkage DN1=450 DN2=350 | STA-12R |
| LP diameter | 12 |
| LP fixed ring | Ceramic |
| LP rotating ring | Graphite |
| LP elastomer | NBR |
Materials
| 1.0 - Pump body | Reinforced technopolymer |
| 2.2 - Suction cover | Stainless steel EN 1.4301 (AISI 304) |
| 3.0 - Impeller | Reinforced technopolymer |
| 4.0 - Pump shaft | Stainless steel EN 1.4057 (AISI 431) |
| 5.1 - Diffuser | Reinforced technopolymer |
| 6.0 - Motor holder | Stainless steel EN 1.4301 (AISI 304) |
| 6.1 - Engine cover | Stainless steel EN 1.4301 (AISI 304) |
| 8.0 - Suction Grid/Filter | Reinforced technopolymer |



