RXm 3/20 (10m) - Single-phase VORTEX electric pump for dirty water, 0.75 HP
Flow rate up to 240 l/min (10.8 m³/h). Head up to 10 m. 0.37 Kw (0.5 HP) motor.
WITH FLOAT
The RXm 3/20 submersible electric pump from the RX-VORTEX series by Pedrollo is made entirely of stainless steel.
Recommended for installations in the domestic and civil sector due to its reliability.
Suitable for draining waste water containing suspended solids up to 20 millimetres in diameter.
The construction solutions used by Pedrollo for the RXm 3/20 guarantee operational safety, even in case of continuous use, thanks to the total cooling of the engine.
It can be installed up to 10 meters below water level with an appropriate length of cable.
- Motor connection
- SINGLE-PHASE
- Power (Kw)
- 0.55
- Power (HP)
- 0.75
- Absorption at 230V (A)
- 3.2
- Capacitor
- 14 µF 450 VL
- Delivery mouth
- 1" 1/4
- Pump body
- AISI 304 stainless steel
- Impeller
- AISI 304 stainless steel
- Number of impellers
- 1
- Crankshaft
- AISI 431 stainless steel
- Check valve
- No
- Degree of protection
- IP 68
- Minimum flow rate (l./min.)
- 20
- Max. flow rate (l./min.)
- 240
- Min. head (m.)
- 2
- Max. head (m.)
- 10
- Cable length (m.)
- 10
- Jobs
- drainage
drying up
slightly dirty waters - Max. liquid temperature (°C)
- +40°C
- Height (cm)
- 33
- Width (cm)
- 14.7
- Weight (Kg)
- 7.3
- Warranty (years)
- 2
RXm models and performances - VORTEX
|
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Construction data of the RX 2/20 series

Bearings
| Pump side motor bearing | 6201 ZZ |
| Opposite side engine bearing | 6201 ZZ |
Tree holding
| Type of seal | Double Seal: Mechanical and Lip with oil chamber |
| LM diameter | 12 |
| LM elastomer | NBR |
| Shrinkage DN1=450 DN2=350 | STA-12R SIC |
| LP diameter | 12 |
| LP fixed ring | Ceramic |
| LP rotating ring | Silicon carbide |
| LP elastomer | NBR |
Materials
| 1.0 - Pump body | Stainless steel EN 1.4301 (AISI 304) |
| 3.0 - Impeller | Stainless steel EN 1.4301 (AISI 304) |
| 4.0 - Pump shaft | Stainless steel EN 1.4057 (AISI 431) |
| 5.1 - Diffuser | Stainless steel EN 1.4301 (AISI 304) |
| 6.0 - Motor holder | Stainless steel EN 1.4301 (AISI 304) |
| 6.1 - Engine cover | Reinforced technopolymer |
| 7.0 - Lantern | Stainless steel EN 1.4301 (AISI 304) |
| 8.0 - Suction Grid/Filter | Stainless steel EN 1.4301 (AISI 304) |



