RXm 2/20 - GM (5m) - Single-phase VORTEX electric pump for dirty water, 0.50 HP
Flow rate up to 190 l/min (10.8 m³/h). Head up to 8 m. 0.37 kW (0.50 HP) motor. WITH MAGNETIC FLOAT.
The RXm 2/20 - GM submersible electric pump from the RX-VORTEX series by Pedrollo is among the best in the submersible drainage category.
Suitable for draining wastewater. Allows the passage of solids up to 20 millimeters.
Recommended for domestic, civil, and industrial installations. Especially for the drainage of wastewater containing suspended solids.
The RXm 2/20 - GM can be installed up to 10 metres below water level.
Pedrollo has made the electric pump entirely of stainless steel for a solid and robust final result.
Complete with vertical sliding magnetic float for installation in small wells.
- Motor connection
- SINGLE-PHASE
- Power (Kw)
- 0.37
- Power (HP)
- 0.50
- Absorption at 230V (A)
- 2.6
- Capacitor
- 10 µF 450 VL
- Delivery mouth
- 1" 1/4
- Pump body
- AISI 304 stainless steel
- Impeller
- AISI 304 stainless steel
- Number of impellers
- 1
- Crankshaft
- AISI 431 stainless steel
- Check valve
- No
- Degree of protection
- IP 68
- Minimum flow rate (l./min.)
- 20
- Max. flow rate (l./min.)
- 190
- Min. head (m.)
- 2
- Max. head (m.)
- 8
- Cable length (m.)
- 5
- Jobs
- drainage
drying up
slightly dirty waters - Max. liquid temperature (°C)
- +40°C
- Height (cm)
- 30
- Width (cm)
- 14.7
- Weight (Kg)
- 6.3
- Warranty (years)
- 2
Models and performances RXm - VORTEX - GM
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||
Construction data of the RX 2/20 series

Bearings
| Pump side motor bearing | 6201 ZZ |
| Opposite side engine bearing | 6201 ZZ |
Tree holding
| Type of seal | Double Seal: Mechanical and Lip with oil chamber |
| LM diameter | 12 |
| LM elastomer | NBR |
| Shrinkage DN1=450 DN2=350 | STA-12R SIC |
| LP diameter | 12 |
| LP fixed ring | Ceramic |
| LP rotating ring | Silicon carbide |
| LP elastomer | NBR |
Materials
| 1.0 - Pump body | Stainless steel EN 1.4301 (AISI 304) |
| 3.0 - Impeller | Stainless steel EN 1.4301 (AISI 304) |
| 4.0 - Pump shaft | Stainless steel EN 1.4057 (AISI 431) |
| 5.1 - Diffuser | Stainless steel EN 1.4301 (AISI 304) |
| 6.0 - Motor holder | Stainless steel EN 1.4301 (AISI 304) |
| 6.1 - Engine cover | Reinforced technopolymer |
| 7.0 - Lantern | Stainless steel EN 1.4301 (AISI 304) |
| 8.0 - Suction Grid/Filter | Stainless steel EN 1.4301 (AISI 304) |



