WA3755.1 10m - 20V Power Supply
Replacement for Worx WR105SI.1, WR141E, WR142E, WR148E, WR184E and Vision WR206E. 10-meter cable.
As an alternative to the WA3755 power supply you can use the WA3750.1 power supply which differs from the WA3755 only in that the plug is of the Schuko type rather than the Italian one.
The other characteristics are identical.
- "Power" - 38 watts
- "Voltage" - 20 volts
- "Current" - 1500 mA
- "Connector" - male
The Worx WA3755.1 power supply is the optimal solution for charging your Landroid.
This power supply is compatible with the charging bases for the Landroid S, M and L models.
It supplies a voltage of 20 volts with a maximum current of 1.5 amps. It is powered by 100-240 volts and consumes 38 watts.
The WA3755.1 takes approximately 1-2 hours to charge your Landoid.
Replacement for Worx WR105SI.1, WR141E, WR142E, WR148E, WR165E, WR167E, WR184E and Vision WR206E.
The charging base connection is a 2-pin male type. It connects to the charging base via a 2-pin connector.
Technology for connection to the power supply and 2-pin connector for connection to the base.
The power connection is a 2-pin Italian male plug. It comes with a 10-meter connection cable.
The Worx 50035691 connection cable allows you to connect the charging station to the power supply to recharge the robot.
The cable is 10 meters long and is made of plastic, which makes it very resistant and allows it to last over time.
Suitable for the following Landroid robot models WR141E, WR155E, WR153E, WR147E and the charging base 50037227.
- Power (Watts)
- 38
- Cable length (m.)
- 10
- Output Voltage (Volts)
- 20
- Line Current (Ampere)
- 1.5
- Type of attack
- male
- Plug
- Italian
