HF 20A - 5.5 HP three-phase centrifugal electric pump
Flow rate up to 1700 l/min (102 m³/h). Head up to 21.5 m. 4 kW (5.5 HP) motor.
The Pedrollo HF 20A submersible pump is recommended for use in the agricultural and industrial sectors.
It has a flow rate that varies from 400 to 1700 litres per minute with a head from 10 to 21.5 metres.
It must be powered by a single-phase voltage, has a horsepower of 5.5 HP and the temperature of the liquid to be pumped ranges from -10 degrees centigrade up to +90.
The high efficiency and the possibility of continuous use make the HF 20A advantageous for flow and sprinkler irrigation, for drawing water from lakes, rivers, wells or for the most varied industrial uses characterised by the need to achieve considerable flow rates in relation to medium-low heads.
- Motor connection
- THREE-PHASE
- Power (Kw)
- 4
- Power (HP)
- 5.5
- Absorption at 230V (A)
- 15.2
- Current consumption at 400V (A)
- 8.8
- Suction mouth
- 4"
- Delivery mouth
- 4"
- Pump body
- Cast iron
- Impeller
- Cast iron
- Number of impellers
- 1
- Crankshaft
- AISI 431 stainless steel
- Check valve
- No
- Degree of protection
- IP 44
- Minimum flow rate (l./min.)
- 400
- Max. flow rate (l./min.)
- 1700
- Min. head (m.)
- 10
- Max. head (m.)
- 21.5
- Jobs
- cooling systems
irrigation
tank transfer
water supply - Max. liquid temperature (°C)
- +90°C
- Motor voltage
- 400 V
- Height (cm)
- 31.2
- Width (cm)
- 47.9
- Depth (cm)
- 25.5
- Weight (Kg)
- 37.1
- Warranty (years)
- 2
HF models and performances - High flow rates
|
|
|
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Construction data of the HF 8A-20A

Bearings
| Pump side motor bearing | 6306 ZZ - C3 |
| Opposite side motor bearing | 6206 ZZ - C3 |
Shaft seal
| Type of seal | Single Mechanical Seal |
| Pump side model | FN-20 |
| LP diameter | 20 |
| Fixed ring LP | Graphite |
| Rotating ring LP | Ceramic |
| LP elastomer | NBR |
Mat
| 1.0 - Pump Body | Cast iron GJL 200 EN 1561 |
| 2.1 - Seal holder cover | Cast iron GJL 200 EN 1561 |
| 3.0 - Impeller | Brass CW617N EN 12165 |
| 4.0 - Pump shaft | EN 1.4057 stainless steel (AISI 431) |
| 6.0 - Motor holder | Aluminum EN-AB 46100 |
| 6.1 - Engine cover | Aluminum EN-AB 46100 |
| 7.0 - Lantern | Aluminum EN-AB 46100 |
