Dm 20 (5m) - 1 HP single-phase clear water pump
Flow rate up to 250 l/min (15 m³/h). Head up to 20 m. 0.75 kW (1 HP) motor. 5 m cable with Schuko plug.
The Dm 20 submersible electric pump from Pedrollo 's D series stands out for its reliability.
Recommended for domestic and civil installations.
Installation can be carried out up to meters below the water level. To ensure continuous operation, the electric pump requires a minimum immersion depth of 210 mm.
Solidity, sturdiness and durability over time are guaranteed by Pedrollo 's use of cast iron, technopolymer and stainless steel in its production.
The cable supplied with the Dm 20 is 5 metres long.
- Motor connection
- SINGLE-PHASE
- Power (Kw)
- 0.75
- Power (HP)
- 1
- Absorption at 230V (A)
- 5.7
- Capacitor
- 20 µF 450 VL
- Delivery mouth
- 1" 1/2
- Pump body
- Cast iron
- Impeller
- Technopolymer
- Number of impellers
- 1
- Crankshaft
- AISI 431 stainless steel
- Check valve
- No
- Degree of protection
- IP 68
- Minimum flow rate (l./min.)
- 25
- Max. flow rate (l./min.)
- 250
- Min. head (m.)
- 8
- Max. head (m.)
- 20
- Cable length (m.)
- 5
- Jobs
- drainage
drying up - Max. liquid temperature (°C)
- +40°C
- Height (cm)
- 34.4
- Weight (Kg)
- 12.9
- Warranty (years)
- 2
Models and performances Dm
|
|
|
|
| ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Construction data of the D series

Bearings
| Pump side motor bearing | 6203 ZZ |
| Opposite side engine bearing | 6203 ZZ |
Tree holding
| Type of seal | Double mechanical seal in oil chamber |
| LM diameter | 14 |
| LM fixed ring | Silicon carbide |
| LM rotating ring | Graphite |
| LM elastomer | NBR |
| Shrinkage DN1=450 DN2=350 | MG1-14D SIC |
| LP diameter | 14 |
| LP fixed ring | Silicon carbide |
| LP rotating ring | Silicon carbide |
| LP elastomer | NBR |
Materials
| 1.0 - Pump body | Cast iron GJL 200 EN 1561 |
| 2.2 - Suction cover | Stainless steel EN 1.4301 (AISI 304) |
| 3.0 - Impeller | Reinforced technopolymer |
| 4.0 - Pump shaft | Stainless steel EN 1.4057 (AISI 431) |
| 6.0 - Motor holder | Stainless steel EN 1.4301 (AISI 304) |
| 6.1 - Engine cover | Stainless steel EN 1.4301 (AISI 304) |
| 7.0 - Lantern | Stainless steel EN 1.4301 (AISI 304) |
| 8.0 - Suction Grid/Filter | Stainless steel EN 1.4301 (AISI 304) |



