2CP 32/210A - 10 HP three-phase twin-impeller centrifugal pump
Flow rate up to 250 l/min (15 m³/h). Head up to 112 m. 7.5 kW (10 HP) motor.
The Pedrollo 2CP 32/210A twin-impeller centrifugal electric pump is recommended for water distribution in combination with pressure tanks, for increasing network pressure and for fire-fighting units.
It can pump clean water and liquids that are chemically non-aggressive for the pump components.
Its adaptability and the guarantee of maintaining high yields make it suitable for use in the domestic, civil and industrial sectors.
To create the 2CP 32/210A, Pedrollo used cast iron, brass, and stainless steel for a robust and long-lasting result.
The flow rate ranges from 40 to 250 litres and the head from 74 to 112 metres.
- Motor connection
- THREE-PHASE
- Power (Kw)
- 7.5
- Power (HP)
- 10
- Absorption at 230V (A)
- 27.7
- Current consumption at 400V (A)
- 16.0
- Suction mouth
- 2"
- Delivery mouth
- 1" 1/4
- Pump body
- Cast iron
- Impeller
- Brass
- Number of impellers
- 2
- Crankshaft
- Stainless steel EN 10088-3 1.4104
- Check valve
- No
- Degree of protection
- IP 44
- Minimum flow rate (l./min.)
- 40
- Max. flow rate (l./min.)
- 250
- Min. head (m.)
- 74
- Max. head (m.)
- 112
- Jobs
- fire prevention systems
pressurization systems
water supply - Max. liquid temperature (°C)
- +90°C
- Height (cm)
- 33.4
- Width (cm)
- 29.2
- Depth (cm)
- 49.6
- Weight (Kg)
- 61
- Warranty (years)
- 2
Models and performances 2CP 32/210
|
|
|
|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Construction data of the 2CP 32/210

Bearings
| Pump side motor bearing | 6306 ZZ-C3 |
| Opposite side engine bearing | 6206 ZZ-C3 |
Tree holding
| Type of seal | Single Mechanical Seal |
| Pump side model | FN-24 |
| LP diameter | 24 |
| LP fixed ring | Graphite |
| LP rotating ring | Ceramic |
| LP elastomer | NBR |
Materials
| 1.1 - Suction Body | Cast iron GJL 200 EN 1561 |
| 1.2 - Pressing Body | Cast iron GJL 200 EN 1561 |
| 3.0 - Impeller | Brass CW617N EN 12165 |
| 4.0 - Pump shaft | Stainless steel EN 1.4057 (AISI 431) |
| 6.0 - Motor holder | Aluminum EN-AB 46126 |



